Proton exchange membrane from the blend of poly(vinylidene fluoride) and functional copolymer: Preparation,proton conductivity,methanol permeability,and stability

A polymer electrolyte membrane is considered as the heart of fuel cells. Here we report the preparation of proton exchange membranes (PEMs) of poly (vinylidene fluoride) (PVDF) blend poly (methyl methacrylate)-co-poly (sodium-4-styrene sulfonate) (PMMA-co-PSSNa) by solvent evaporation method. Three different types of PEMs have been prepared by using different ratios of PVDF and PMMA-co-PSSNa copolymer. We have investigated the effect of concentration of PVDF on water uptake, ion exchange capacity, mechanical, thermal, and oxidative stability, proton conductivity (K^m), and methanol permeability (P_M) of the blend membranes. These blend PEMs showed good physicochemical and electrochemical properties along with thermal and oxidative stability. The membrane prepared from PVDF (45% w/w) to PMMA-co-PSSNa (55% w/w) exhibited optimum P_M at room temperature (8.38 × 10^?7 cm²s^?1). This low fuel crossover and high relative selectivity can make our prepared blend membranes a potential candidate in polymer electrolyte membrane fuel cells (PEMFCs) or direct methanol fuel cells (DMFCs).     

硅酸盐型胶磷矿单一反浮选工艺研究及工业化应用

云南某矿区产的硅酸盐型胶磷矿的SiO_2含量一般在30%以上,堆存数量巨大,使用常规的单一反浮选工艺难以达到要求的精矿指标,但是使用正反浮选工艺或者双反浮选工艺的生产成本又较高,经济效益不理想。从矿石的多元素分析发现,与CaO∶P_2O_5大于1.79的碳酸型磷块岩配矿后使用单反浮选工艺可以获得合格的精矿指标。在此思路上,对两种矿石进行配合比、解离度、磨矿细度和药剂制度的探索研究。当配合比为1∶3,磨矿细度为92%,药剂制度为抑制剂1.5kg/t、调整剂18kg/t、捕收剂3.0kg/t的情况下,最终可以获得P_2O_5品位为28.89%,MgO品位为0.91%,产率62.73%,回收率85.24%的精矿指标。     

豫西吉家洼金矿床主矿脉找矿前景分析

吉家洼金矿床位于豫西熊耳山上宫金矿集区的西部。通过对矿床地质、主要矿脉地质特征研究,对F1、F2和WF1矿脉进行了矿体趋势预测和找矿前景分析。分析结果表明,WF1矿脉北中部125～119线间、中部123～107线间及南部100～114线间,深部具有较大的找矿潜力;F1、F2矿脉11～8线为找矿有利地段,具有进一步找矿空间。     

紫金山东南矿段成矿期次、阶段浅析

通过对紫金山东南矿段铜钼(金)矿床地质矿化特征分析,指出铜钼矿化带主要赋存于花岗闪长斑岩的内外接触带,处于似斑状花岗闪长斑岩的上部,金矿化带赋存在表生氧化带的英安玢岩、隐爆角砾岩中。经过对矿石的组构特征、矿物生成顺序等特征分析,将矿床的成矿演化过程分为斑岩热液期、高硫化浅成低温热液期、表生氧化期三个主要矿化期次,进一步将斑岩热液期分为黑云母-钾长石化阶段、石英-绢云母化阶段、碳酸盐化阶段三个阶段;高硫化浅成低温热液期分为地开石化阶段、明矾石化阶段、硅化阶段三个阶段。研究结果为进一步研究矿床成因提供了依据。     

瑞木矿区配矿实践

通过对品位高低不同的矿石按比例进行互相搭配,尽量使之混合均匀调配成满足矿山生产矿石指标要求,降低损失率、提高回收率。     

贵州省道真县大塘铝土矿矿石特征

本次对大塘铝土矿研究区进行矿石类型划分,对其矿物、化学成分等进行研究,得出矿石特征及成因。矿石矿物以铝矿物为主,隐晶、豆状、粒屑结构等,块状构造,其主要化学成分为Al2O3、SiO2、Fe2O3、TS、TiO2。铝土矿石赋存层位为大竹园组,属Ⅳ-Ⅴ级品,产于遭受长期风化剥蚀的古陆边缘,为古风化壳沉积型矿床。     

Stability of Cold-Pressed Oil from Commercial Indian Niger (Guizotia abyssinica (L.f.) Cass.) Seed as affected by Blending and Interesterification

Blending and interesterification of cold‐pressed oil from commercially available niger (Guizotia abyssinica (L.f.) Cass.) seeds was performed to improve its stability. The fatty acid composition of cold‐pressed niger seed oil (NSO) revealed that it contained a huge amount of polyunsaturated linoleic acid (69.2 %). NSO being rich in polyunsaturated fatty acids (PUFA) was susceptible to oxidation and hence was blended with saturated fatty acid (SFA) rich coconut oil (CNO) and monounsaturated fatty acid (MUFA) rich olive–pomace oil (OO) to enhance its stability. CNO contained a total of 91.3 % of SFA, while OO had oleic acid, C18:1 (74.3 %) as MUFA. Two blends of NSO with CNO and OO, i.e. NSO + CNO(B) and NSO + OO(B), were prepared in the ratio of 1:1. The blends were further interesterified using the lipase enzyme from Rhizomucor meihei and interesterified oils, i.e. NSO + CNO(I) and NSO + OO(I), were obtained. The oxidative stability of the oils was evaluated by incubating them at 37 °C and 55 % relative humidity (RH) for a period of 45 days. The peroxide values of NSO + CNO(B), NSO + OO(B), NSO + CNO(I) and NSO + OO(I) showed a reduction by 53.3, 42.6, 65.3 and 55.4 %, respectively, while the conjugated diene values showed a reduction by 75.0, 66.9, 76.7 and 75.3 %, respectively, as compared to NSO during the incubation period. This is probably the first report on the stability improvement of niger seed oil through blending and interesterification.     

MgO含量对高铝烧结矿冶金性能的影响

为了改善高铝烧结矿对高炉冶炼不利的影响,本文在实验室条件下研究了Mg O含量对高铝烧结矿冶金性能的影响。实验结果表明:当烧结矿中Mg O含量为2.5%左右时,烧结矿的转鼓指数、低温还原粉化指数为最高,分别达到了了68.24%和72.58%;烧结矿的成品率较高,粒度分布合理;烧结矿的软熔区间较窄,对高炉生产有利。     

用于FDM的导电ABS/MWCNT复合材料的制备

采用熔融共混法将丙烯腈-丁二烯-苯乙烯共聚物(ABS)与多壁碳纳米管(MWCNT)复合,并对所得的复合材料进行了力学性能、热性能和电学性能分析。结果表明,添加MWCNT能够提高复合材料的力学性能、电导率和耐热性,力学性能在MWCNT添加量为2%时最佳,电导率随MWCNT添加量的增加而增大,MWCNT添加量为4%时,其电导率能达到4.35×10-6S/m。将添加4%MWCNT的复合材料拉丝,然后以三种打印方向进行熔融沉积(FDM)打印,研究了打印试样的力学性能,用扫描电镜(SEM)观察了其断面形貌。结果表明,水平方向打印的试样力学强度最好,侧向打印的试样次之,垂直方向打印的样品由于仅靠丝材的层间黏结,其力学强度比较差,与纯ABS丝材打印试样相比,复合丝材打印试样的拉伸强度和弯曲强度均有明显提高,冲击强度有所下降。     

四川某粘土型钒矿工艺矿物学研究

通过矿相显微镜、扫描电子显微镜、电子探针、X射线能谱元素面分析等多种手段综合研究四川某地黏土型钒矿中钒的赋存状态。样品为铝质黏土岩，V2O5含量为0.93%。黏土矿物总量为61.7%，石英含量13.4%，黄铁矿含量17.1%。样品具典型的黏土结构，矿物粒度微细。钒有两种赋存状态，一种呈钒云母的独立矿物形式存在，另一种则呈类质同相的形式存在于绢云母和伊利石中。典型测点平均含钒量为0.873%，fm-5测点钒含量2.143%，为钒云母；fm-6测点钒含量0.138%，为含钒伊利石；fm-7测点钒含量0.333%，为含钒绢云母。与钒云母、伊利石、绢云母三者结构相似，且粒度极其微细，无法分离，故应作为一个整体单元来回收利用钒。建议通过浮选脱除黄铁矿，然后通过擦洗—脱泥的方式对石英和黏土矿物进行分离，从而实现钒的富集。